◎ 型號含義 Type meaning

① 1 路 One channel

② 控制電壓 3-32VDC Control voltage 3-32VDC

③ 直流控直流 DC-DC (DC input-DC output)

④ 負載電壓 5-60VDC

Load voltage 5-60VDC

⑤ 200A, 300A, 400A, 600A

◎ 產(chǎn)品概述 Product overview

◆ 直流固態(tài)繼電器易并聯(lián)，適合大電流應用場合

◆ 額定電流：200A-600Amps

◆ 額定電壓：5-60VDC

◆ 控制電流：≤ 40mA

◆ 低輸出斷態(tài)漏電流

◆ 低阻抗 MOSFET 輸出，最大限度減少總功耗

◆ 適合阻性負載和感性負載 ( 感性負載如電機和 EMR/電磁線圈等必須加裝抑制二極管 )

◆ 具有 LED 燈輸出指示

◆ 包含標準輸出的 R-C 緩沖器

◆ 透明保護蓋為用戶提供額外保護

◆ DC solid state relays are easy to connect inparallel, suitable for high current applications

◆ Rated current: 200A-600Amps

◆ Rated voltage: 5-60VDC

◆ Control current: ≤ 40mA

◆ Low output off-state leakage current

◆Low-impedance MOSFET as the output component minimize the total power consumption

◆ Suitable for resistive load and inductive load (the inductive load, such as motor and EMR / electromagnetic coil, must be equipped with the suppressor diode)

◆ Display output status via LED

◆ Standard output R-C buffer

◆ Transparent cover for extra protection

注意 :

1. 當負載電流為 10A 時 , 必須加裝散熱器 ; 為 40A 及以上時 , 必須加風扇強冷或水冷 .

2. 使用感性負載時 , 務必在輸出端并接一個壓敏電阻 , 取值為負載電壓的 1.6-1.9 倍 .

Notice:

1. If the load current is 10A, a heat sink must be equipped; if the load current is 40A or more, an air-cooled radiator or a water-cooled radiator must be installed.

2. When the load is an inductive load, be sure to connect a varistor in parallel with the output terminal, whose voltage value is 1.6-1.9 times the load voltage.

◎ 安裝尺寸及接線圖 Installation dimensions and wiring diagram

注：特殊電壓可定做。Note: Specific voltage can be customized.